Dell PowerVault DR2000v - Manual (Page 40)

network --create_eth
Description
The command creates eth interface for the system.
Syntax
network --create_eth --nwif
[--dhcp]
[--static]
[--name < DNS name >]
[--mtu ]
[--ip ]
[--netmask ]
[--restart]
--nwif Eth interface to create.
--dhcp Create dhcp interface.
--static Create static interface.
--name DNS name for the interface.
--mtu Ethernet MTU to use (valid range is 512 - 9000).
--ip Static IP address to use.
--netmask Netmask for the static IP address.
--restart Restarts networking after creation.
For example, to create eth2, run the command: network --create_eth --nwif eth2 --dhcp
Result
Interface operation successful. Please restart networking for the changes to
take effect.
network --add_member
Description
Add an interface to an existing bond.
Syntax
network --add_member --bondif
--nwif
--bondif Bond interface to add to.
--nwif Eth interfaces to add.
For example, to add eth2 to bond1, run the command: network --add_member --bondif bond1 --nwif
eth2
Result
Interface add successful. Please restart networking for the changes to take
effect.
40