Replication --stop --name --role Page 132
Page 132
Syntax
replication --delete --name acme-59-replica --role target
If you attempt to delete a container that already has replication enabled, this displays the following message:
Replication on acme-59-replica is enabled and cannot be deleted, please stop it
first.
NOTE: If the replication state of the link is enabled, you must use the replication --stop command to disable
replication before you can delete the replication link. For more information, see
.
Deletes the existing replication link to a container.
replication --delete --name acme-59-replica --role source
Result
Successfully deleted replication entry.
NOTE: The DR Series system CLI --force command is optional, and this command allows you to force the deletion
of an existing replication link (such as when communications between the source and target are not working).
replication --start --name
Description
Starts the replication process on an existing replication link to a container in a DR Series system.
Syntax
replication --start --name container2_replica --role target
Result
Replication configuration updated successfully.
Replication Container : container2_replica
Replication Role : Source
Replication Target System : acme-85
Replication Target System IP : 10.20.22.20
Replication Target Container : acme85-S2
Replication Enabled : Yes
Replication Compression Enabled : Yes
Replication Encryption : AES 128-bit
replication --stop --name
Description
Stops the replication process on an existing replication link to a container in a DR Series system.
Syntax
replication --stop --name acme-59_replicate --role source
Result
Replication configuration updated successfully.
Replication Container : acme59
Replication Role : Source
Replication Target System : acme-85
Replication Target System IP : 10.20.22.20
Replication Target Container : acme85-S2
132