Dell PowerVault DR2000v - Manual (Page 89)

Result
Telnet State : Disabled
NOTE: In this example, the system --telnet command output showed the telnet access status as disabled. The
following example shows the command for enabling telnet access on your DR Series system. To disable telnet
access, use the system --telnet --disable command.
system --telnet --enable
Successfully enabled telnet.
system --datacheck [--enable ]
Enables one or both Data Check scan options that can be used on a DR Series system. You can individually enable
namespace or blockmap scan options, or both options using the all scan option (which means that both the namespace
and blockmap scan types will be enabled).
Description
Enables an individual Data Check scan option type (or both scan types) when used in a DR Series system CLI command.
Syntax
system --datacheck --enable all
Result
Data Check configuration successful: namespace and blockmap scans currently
enabled.
NOTE: This example shows all Data Check scan options enabled. To enable only the namespace or only the
blockmap scan, simply replace the all option with either of the other option types you desire in the DR Series
system CLI command.
system --datacheck [--disable ]
Disables one or both Data Check scan option types that can be used on a DR Series system. You can individually disable
namespace or blockmap scan options, or both options using the all scan option (which means that both the namespace
and blockmap scan types will be disabled).
Description
Disables an individual Data Check scan option type (or both scan types) when used in a DR Series system CLI command.
Syntax
system --datacheck --disable all
Result
Data Check configuration successful: all scans currently disabled.
NOTE: This example shows all Data Check scan options being disabled. To disable only the namespace or the
blockmap scan, simply replace the all option with either of the other option types you desire in the DR Series
system CLI command.
89