Dell PowerEdge R210 - Manual (Page 61)

4. Ensure that the expansion-card riser is firmly seated in its connector. See Installing an Expansion Card .
5. Ensure that the expansion card is firmly seated in its connector. See Installing an Expansion Card .
6. Close the system. See Closing the System .
7. If the problem is not resolved, turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
8. Open the system. See Opening the System .
9. Remove the expansion card. See Removing an Expansion Card .
10. Close the system. See Closing the System .
11. Run the appropriate online diagnostic test.
If the tests fail, see Getting Help .
Troubleshooting the Processor
1. Run the appropriate online diagnostics test. See Using Online Diagnostics .
2. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
3. Open the system. See Opening the System .
4. Ensure that the processor and heat sink are properly installed. See Processor .
5. Close the system. See Closing the System .
6. Run the appropriate online diagnostic test.
If a problem is still indicated, see Getting Help .
Back to Contents Page
WARNING: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before you begin this procedure, review the safety instructions that came with the system.