Dell PowerEdge R210 - Manual (Page 32)

4. Remove the plastic filler plug for the iDRAC6 Enterprise port from the system back panel.
5. Angle the card so that the RJ-45 connector fits through the back-panel opening. See Figure 3 -14 .
6. Align the front edge of the card with the two front plastic retention standoffs next to the iDRAC6 connector on the system board, and lower the card into
place. See
Figure 3 -14 .
When the front of the card is fully seated, the plastic standoffs snap over the edge of the card.
Figure 3-14. Installing or Removing an iDRAC6 Enterprise Card
7. If applicable, reinstall the expansion card. See Installing an Expansion Card .
8. Close the system. See Closing the System .
9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Removing an iDRAC6 Enterprise Card
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. If present, disconnect the Ethernet cable from the iDRAC6 enterprise card connector on the system back panel. See Figure 1 -2 .
3. Open the system. See Opening the System .
4. If installed, remove the expansion card from the expansion slot. See Removing an Expansion Card .
5. Remove the VFlash media (if installed) from the iDRAC6 enterprise card. See Removing a VFlash Media Card .
6. Pull back slightly on the two tabs at the front edge of the card and gently lift the front edge of the card off of the retention standoffs.
As the card releases from the standoffs, the connector under the card disengages from the system board connector.
7. Slide the card away from the back of the system until the RJ-45 connector is clear of the back panel, then lift the card out of the system.
8. If applicable, reinstall the expansion card. See Installing an Expansion Card .
9. Replace the plastic filler plug over the port at the system back panel. See Back-Panel Features and Indicators for the port location.
10. Close the system. See Closing the System .
1 iDRAC6 Enterprise card 2 VFlash media slot
3 VFlash SD card 4 retention standoff posts (2)
5 retention standoff tabs (2) 6 iDRAC6 Enterprise card connector
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.