Dell PowerEdge R210 - Manual (Page 40)

6. Tighten the ten screws that secure the system board to the chassis. See Figure 3 -20 .
7. Transfer the processor and the heat sink to the new system board. See Removing a Processor and Installing a Processor .
8. Replace all the memory modules and memory blanks. See Installing Memory Modules .
9. Connect the cables in the order listed below (see Figure 6 -1 for the locations of the connectors on the system board):
l SATA interface cable, if applicable
l Control panel interface cable
l Optical drive power cable
l Control panel USB interface cable
l System board power cables
10. Install the expansion card, if any. See Installing an Expansion Card .
11. If applicable, reinstall the iDRAC6 Enterprise card. See Installing an iDRAC6 Enterprise Card .
12. If applicable, reinstall the iDRAC6 Express card. See Installing an iDRAC6 Express Card .
13. Replace the cooling shroud. See Installing the Cooling Shroud .
14. Close the system. See Closing the System .
15. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Back to Contents Page