Sink retention screws. see, Figure 3, Installing a processor – Dell PowerEdge R210 User Manual
Page 34
Figure 3-15. Installing and Removing the Heat Sink
11.
Rotate the processor shield upward and out of the way. See
.
12.
Lift the processor out of the socket and leave the release lever up so that the socket is ready for the new processor.
Figure 3-16. Installing and Removing a Processor
Installing a Processor
1.
If you are upgrading your processor, prior to upgrading your system, download and install the latest system BIOS version from support.dell.com. Follow
the instructions included in the file download to install the update on your system.
1
heat-sink retention screws (4)
2
heat sink
CAUTION:
Be careful not to bend any of the pins on the ZIF socket when removing the processor. Bending the pins can permanently damage the
system board.
1
processor
2
notch in processor
3
socket key
4
ZIF socket
5
processor shield
6
socket-release lever
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.