Dell PowerEdge R210 - Manual (Page 25)

Installing an Expansion-Card Riser
1. Align the expansion-card riser with the riser guide posts on the system board. See Figure 3 -8 .
2. Lower the expansion-card riser into place until the expansion-card riser connector is fully seated.
3. If applicable, reinstall the expansion card. See Installing an Expansion Card .
4. Close the system. See Closing the System .
5. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Internal USB Memory Key
The USB memory key can be used as a boot device, security key, or mass storage device. To use the internal USB connector, the Internal USB Port option
must be enabled in the Integrated Devices screen of the System Setup program.
To boot from the USB memory key, you must configure the USB memory key with a boot image and then specify the USB memory key in the boot sequence in
the System Setup program. See
Boot Settings Screen . For information on creating a bootable file on the USB memory key, see the user documentation that
accompanied the USB memory key.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system. See Opening the System .
3. Locate the USB connector on the control panel board. See Figure 3 -19 .
4. Insert the USB memory key into the USB connector.
5. Close the system. See Closing the System .
6. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 3-9. Removing or Installing a USB Memory Key
1 release tab 2 expansion-card riser
3 expansion-card slot 4 riser guide posts (2)
5 expansion-card riser connector
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: To avoid interference with other components, the maximum allowable dimensions of the USB key are 24 mm (.94 in) wide x 79 mm (3.11 in) long
x 8.6 mm (.33 in) high.