Dell PowerVault MD3200i - Manual (Page 79)

Configuration: About Your Storage Array 79
• The e-mail addresses that you had previously configured are displayed in
the Configured e-mail addresses area.
• You must use fully qualified e-mail addresses, for example,
[email protected].
• You can configure multiple e-mail addresses before you click OK.
Configuring SNMP Alerts
To add a management console to the list of addresses configured to receive
SNMP alerts:
1 Open the Configure Alerts dialog by performing one of these actions:
• In the Tree view or the Table view on the Devices tab in the EMW,
select a node, and select Edit Configure Alerts. Go to step 3.
• In the Setup tab in the EMW, select Configure Alerts. Go to step 2.
2 Select one of the following radio buttons to specify an alert level:
• All storage arrays—Select this option to send an alert notification
about events on all storage arrays.
• An individual storage array—Select this option to send an alert
notification about events that occur in only a specified storage array.
These results occur, depending on your selection:
• If you selected All storage arrays, the
Configure Alerts dialog is
displayed.
• If you selected An individual storage array, the Select Storage Array
dialog is displayed. Select the storage array for which you want to
receive alert notifications and click OK. The Configure Alerts dialog is
displayed.
NOTE: If you do not know which storage array to select, click Blink to turn on
the LEDs of the storage array.
3 Select the SNMP tab to configure the SNMP alert destinations.
• Adding an SNMP address—In Community name, type the
community name. In Trap destination, type the trap destination, and
click Add.
book.book Page 79 Tuesday, June 18, 2013 3:15 PM