Dell PowerVault MD3200i - Manual (Page 76)

76 Configuration: About Your Storage Array
3 Click OK.
If you have set a password for the selected storage array, the Enter
Password dialog is displayed.
4 Type the current password for the storage array.
5 Click OK.
Configuring Alert Notifications
MDSM can send an alert for any condition on the storage array that requires
your attention. Alerts can be sent as e-mail messages or as Simple Network
Management Protocol (SNMP) trap messages.
You can configure alert notifications either for all the storage arrays or a single
storage array.
To configure alert notifications for all storage arrays:
1 In the EMW, select the Setup tab.
2 Select Configure Alerts.
The Configure Alerts dialog is displayed.
3 Select All storage arrays.
4 Click OK.
The Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 76. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 79.
To configure alert notifications for a single storage array:
1 In the EMW, select the Devices tab.
2 Select the relevant storage array, then select EditConfigure Alerts.
The Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 76. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 79.
Configuring E-mail Alerts
For more information on configuring alert notifications, see "Configuring
Alert Notifications" on page 76.
book.book Page 76 Tuesday, June 18, 2013 3:15 PM