Dell PowerVault MD3200i - Manual (Page 78)

78 Configuration: About Your Storage Array
• Adding an e-mail address—In Email address, type the e-mail address,
and click Add.
• Replacing an e-mail address—In the Configured email addresses area,
select the e-mail address to be replaced, type the replacement e-mail
address in Email address, and click Replace.
• Deleting an e-mail address—In the Configured email addresses area,
select the e-mail address, and click Delete.
• Validating an e-mail address—Type the e-mail address in Email
address or select the e-mail address in the Configured email addresses
area, and click Test. A test e-mail is sent to the selected e-mail address.
A dialog with the results of the test and any error is displayed.
8 For the selected e-mail address, in Information To Send, select:
• Event Only—The alert e-mail contains only the event information.
This alert type is the default.
• Event + Profile—The alert e-mail contains the event information and
the storage array profile.
• Event + Support—The alert e-mail contains the event information
and a compressed file that contains complete support information for
the storage array that has generated the alert.
9 For the selected e-mail address, in Frequency, select:
• Every event—Sends an alert e-mail whenever an event occurs. This is
the default option.
• Every x hours—Sends an alert e-mail after the specified time interval
if an event occurred during that time interval. You can select this
option only if you have selected either Event + Profile or Event +
Support in the Information To Send drop down list.
10 Click OK.
An alert icon is displayed next to each node in the Tree view where an alert
is set.
To ensure that the e-mail is sent successfully:
• You must provide an SMTP mail server name and an e-mail sender address
for the e-mail addresses to work.
book.book Page 78 Tuesday, June 18, 2013 3:15 PM