Dell PowerVault MD3200i - Manual (Page 70)

70 Configuration: About Your Storage Array
• In the AMW, select Storage ArrayBlinkStorage Array.
The LEDs blink on the physical disks in the storage array.
2 After locating the storage array, click OK.
The LEDs stop blinking.
3 If the LEDs do not stop blinking, select Storage ArrayBlink Stop All
Indications.
A confirmation message is displayed.
4 Click OK.
Naming or Renaming Storage Arrays
Each storage array must be assigned a unique up to 30-character
alphanumeric name. A name can consist of letters, numbers, and the special
characters underscore (_), dash (–), and pound sign (#). No other special
characters are allowed.
To rename a selected storage array:
1 Perform one of these actions:
• In the AMW Setup tab, select Rename Storage Array.
• In the EMW Devices tab Tree view, select Edit Rename.
• In the EMW Devices tab Table view, select Edit Rename.
• In the EMW Devices tab Tree view, right-click on the desired array
icon and select Rename.
The Name/Rename Storage Arrays dialog is displayed.
2 Select the relevant storage array from the Select storage array table.
If you do not know the name or physical location of the storage array, click
Blink. After locating the storage array, click OK to turn off the LEDs.
The name of the storage array is displayed in the
Storage array name.
3 In Storage array name, type the new name of the storage array. If
applicable, add a comment for the storage array in Additional comment.
4 Click Apply.
A message is displayed warning you about the implications of changing the
storage array name.
book.book Page 70 Tuesday, June 18, 2013 3:15 PM