Dell UPS 4200R - Manual (Page 18)

Installation 19
Figure 3. Login Screen
Configuration
When started, the application automatically performs a discovery using the “Quick Scan” option:
• Using the “Quick Scan” operation, you will discover, through broadcast, within a few seconds, all
Dell UPS Management Cards, Dell PDUs, and Dell UPS Local Node Manager (ULNM)(or Dell
ULNMs)on the local subnet network.
• The discovered nodes are displayed using Settings > Auto Discovery (see Figure 4).
• For the other nodes, perform the discovery based on IP address ranges using the “Range Scan” option.
Using “Range Scan” discovers the nodes that are outside of the network segment and nodes that are
not compatible with the “Quick Scan” feature.
• Refer to the Compatibility list to determine if your node supports “Quick Scan” feature.
(Optional) If you want the computer running Dell MUMC to shut down in the event of a power failure:
Use Settings > Shutdown > Module Settings to activate the shutdown module.
From the Settings > Shutdown page, assign the following:
• IP address of the UPS that powers the local Computer
• The access parameters through the login and password entries.
License Code
The Dell MUMC monitors up to 32 devices (including Dell UPSs, Dell PDUs, and Dell Network
Management Card) without a license key.
If there are more devices to be monitored, an appropriate license is needed. The license can also be
upgraded later without reinstallation.
0119_2-Dell MUMC UG.book Page 19 Saturday, November 2, 2013 4:59 PM