Dell UPS 4200R - Manual (Page 100)

Redundancy 101
Then, the new node is created:
• You can see it in the “Autodiscovery” node list.
• You can select it as power source.
• You can edit composite device properties by selecting it in the discovery view then click again on the
“Set composite device” menu item.
• If you select components of a composite device and click on the “Set composite device” menu item
again, properties of existing composite device are shown; no new composite device is created so no
composite device duplication is possible.
• The created “Virtual Power Source” is counted as a node for the licensing node limitation.
Redundancy Views
Redundancy View in Node List
When a composite device is selected in the node list, the user can view it in the selection view, with
following information:
• Dedicated states in “Information” and “Status” panels
• “Events” panel shows events from the composite devices and all its child components
A dedicated “Power components” panel displays component states, including load level and battery run
time.
Figure 84. Virtual Power Source in Node List View
0119_2-Dell MUMC UG.book Page 101 Saturday, November 2, 2013 4:59 PM