Stop storage array blink – Dell PowerVault MD3420 User Manual
Page 392
744 GB
0 %
931 GB
0 %
1117 GB
0 %
1303 GB
0 %
1489 GB
0 %
1675 GB
0 %
1862 GB
0 %
* = Current SSD cache physical capacity.
Stop Storage Array Blink
Description
This command turns off the indicator lights on the storage array that were turned on by the start
storageArray blink command.
Syntax
stop storageArray blink
Parameters
None.
Stop Storage Array Configuration Database Diagnostic
Description
This command stops the diagnostic test to validate the configuration database in the RAID controller
module firmware that was started by the start storageArray configDbDiagnostic command.
Syntax
stop storageArray configDbDiagnostic
Parameters
None.
Notes
The RAID controller module firmware returns a confirmation that the diagnostic test was cancelled.
In addition, you can start the database configuration diagnostic test through the storage management
software GUI; however, you cannot stop the database configuration diagnostic test through the storage
management software GUI. If you want to stop a running diagnostic test, you must use the stop
storageArray configDbDiagnostic command.
392