Dell PowerVault MD3420 - Manual (Page 280)

not work because of hardware errors. In a Forced state, the disk group can be imported, and you can
then identify the hardware errors.
Syntax
set diskGroup [diskGroupName] forcedState
Parameters
Parameter Description
diskGroup Sequence number of the disk group for which to
set properties. You must put brackets ([ ]) around
the disk group number.
NOTE: You can move the physical disks that comprise a disk group from one storage array to
another storage array. The CLI provides three commands that let you move the physical disks. The
commands are start diskGroup export, start diskGroup import, and set diskGroup
forcedState. In the Forced state, you can perform an import operation on the disk group.
Set Disk Pool
Description
This command sets the attributes associated with a disk pool based on the specified parameters.
Syntax
set diskPool
(diskPool=[diskPoolName] | diskPools=[diskPoolName1... diskPoolNamen] |
allDiskPools)
[reservePhysicalDiskCount=reservePhysicalDiskCountValue |
warningThreshold=(warningThresholdValue | default) |
criticalThreshold=(criticalThresholdValue | default) |
criticalPriority=(highest|high|medium|low|lowest) |
backgroundPriority=(highest|high|medium|low|lowest) |
degradedPriority=(highest|high|medium|low|lowest)
userLabel=diskPoolName]
Parameters
Parameter Description
diskPools The list of diskPoolNames identifies multiple
physical disk pool which have their parameters
reset by the command.
allDiskPools This parameter specifies that all physical disk pools
have their parameters reset by the command.
reservePhysicalDiskCount This value is specified in terms of the number of
physical disks to reserve in the disk pool for
physical disk failures or physical disk removals.
280