Dell PowerVault MD3420 - Manual (Page 374)

Syntax
start asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"]
synchronize [deleteRecoveryPointIfNecessary]
Parameter
Parameter Description
asyncRemoteReplicationGroup The name of the remote replication group for
which you want to start synchronization. Enclose
the remote replication group name in double
quotation marks (" ") inside square brackets ([ ]").
deleteRecoveryPointIfNecessary The parameter to delete the recovery point if the
recoverable synchronization data has exceeded
time threshold for recovery. Recovery point age is
measured from the time the data was frozen on
the primary storage array.
Start Remote Replication (Legacy) Synchronization
Description
NOTE: This command valid only with Fibre Channel storage arrays.
This command starts Remote Replication (legacy) synchronization.
Syntax
start remoteReplication primary
[”virtualDiskName”] synchronize
Parameters
Parameter Description
primary The name of the primary virtual disk for which you
want to start synchronization. Enclose the primary
virtual disk name in double quotation marks (“ ”)
inside square brackets ([ ]).
Start Secure Physical Disk Erase
Description
This command erases all of the data from one or more self-encrypting disk (SED) physical disks so that
they can be reused as SED physical disks. Run this command only when the SED physical disks are no
longer part of a secure disk group, or when the security key is unknown.
374