Dell PowerVault MD3420 - Manual (Page 284)

imported with the physical disks of a disk group that are transferred to a new storage array. The latter
failure creates an incomplete disk group on the new storage array.
Description
Run this command to add the missing (foreign) physical disks back into their original disk group and to
make them part of the new storage array disk group configuration of the new storage array.
Use this operation for emergency recovery only: when one or more physical disks must be changed from
a foreign physical disk status and returned to a native status within their original disk group.
CAUTION: Using this command for purposes other than what is stated above might result in data
corruption or data loss without notification.
Syntax
set (physicalDisk [enclosureID,slotID] |
physicalDisks [enclosureID1,slotID1 enclosureID2, slotID2...
enclosureIDn,slotIDn]|
allPhysicalDisks) nativeState
Parameters
Parameter Description
physicalDisk or physicalDisks The enclosure and the slot where the physical disk
resides. Enclosure ID values are 0 to 99. Slot ID
values are 0 to 31. Enclose the enclosure ID values
and the slot ID values in square brackets ([ ]).
allPhysicalDisks Selects all the physical disks.
Set Host
Description
This command assigns a host to a host group or moves a host to a different host group. You can also
create a new host group and assign the host to the new host group with this command. The actions
performed by this command depend on whether the host has individual mappings or does not have
individual mappings.
Syntax
set host [hostName]
hostGroup=("hostGroupName" | none | defaultGroup)
userLabel="newHostName"
hostType=(hostTypeIndexLabel | hostTypeIndexNumber)
Parameters
Parameter Description
host The name of the host that you want to assign to a
host group. Enclose the host name in square
284