Dell PowerVault MD3420 - Manual (Page 246)

Parameter Description
CAUTION: The host agent uses the access
virtual disks to communicate in-band with a
storage array. If you remove an access virtual
disk mapping for a storage array from a host
that has an agent running on it, the storage
management software is no longer able to
manage the storage array through the in-
band agent.
host Name of the host to which the virtual disk is
mapped. You must put quotation marks (" ") around
the host name.
hostGroup Name of the host group that contains the host to
which the virtual disk is mapped. You must put
quotation marks (" ") around the host group name.
NOTE: You must use the host and hostGroup parameters when specifying a nonaccess virtual disk
or an access virtual disk. The script engine ignores the host or hostGroup parameters when you
use the allVirtualDisks or virtualDisks parameters.
Rename A Snapshot Virtual Disk
Description
This command renames an existing snapshot virtual disk.
Syntax
set snapVirtualDisk ["snapVirtualDiskName"]
userLabel="snapImageVirtualDiskName"
Parameters
Parameter Description
snapVirtualDisk The name of the snapshot virtual disk that you
want to rename. Enclose the snapshot virtual disk
name in double quotation marks (" ") inside of
square brackets ([ ]).
userLabel A new name that you want to give to the snapshot
virtual disk. Enclose the new snapshot virtual disk
name in double quotation marks (" ").
Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for
the names. Names can have a maximum of 30 characters.
246