Verifying the ip settings, The operator panel, The system settings report – Dell C1765NF MFP Laser Printer User Manual
Page 57: The ping command
Setting the IP Address
55
Verifying the IP Settings
You can confirm the settings by using the operator panel, printing the printer settings report, or using the ping
command.
NOTE:
A Password is required to enter
Admin Menu
when
Panel Lock Set
is set to
Enable
. In this case, enter the
password you specified, and press the
(Set) button.
The Operator Panel
1 Press the
(Menu) button.
2 Press the
button until System appears, and then press the
(set) button.
3 Press the
button until Admin Menu appears, and then press the
(set) button.
4 Press the
button until Network appears, and then press the
(set) button.
5 Press the
button until TCP/IP appears, and then press the
(set) button.
6 Press the
button until IPv4 appears, and then press the
(set) button.
Check the IP address displayed on the operator panel.
The System Settings Report
1 Print the system settings report.
For details about how to print a system settings report, see "Printing a Report/List Using the Operator Panel" on
2 Verify the correct IP address, subnet mask, and gateway address are listed in the system settings report under Wired
Network or Wireless Network.
If the IP address shows 0.0.0.0 (the factory default), an IP address has not been assigned. To assign one for your
printer, see "Assigning an IP Address" on page 53.
The Ping Command
Ping the printer and verify that it responds. For example, at a command prompt on a network computer, type ping
followed by the new IP address (for example, 192.168.0.11):
ping 192.168.0.11
If the printer is active on the network, you will receive a reply.