Dell C1765NF MFP Laser Printer - Manual (Page 148)

146 Understanding the Tool Box Menus
Printer Maintenance
The Printer Maintenance tab contains the System Settings, Date & Time, Paper Density, Adjust Transfer Roller,
Adjust Fusing Unit, Registration Adjustment, Adjust Altitude, Reset Defaults, Non-Dell Toner, Transfer Roller
Refresh Mode, Web Link Customization, TCP/IP Settings, Tray Settings, EWS, Scan Defaults, Fax Defaults,
Copy Defaults, and Fax Settings pages.
System Settings
Purpose:
To configure the power saving mode, auto clear time, warning tones, time-out time, operator panel language
settings, job log auto print, and mm/inch setting.
Values:
Fax Transmit Displays whether to print a transmission report after every fax transmission or only
when an error occurs.
Fax Broadcast Displays whether to print a transmission report after every fax transmission to
multiple destinations or only when an error occurs.
Fax Protocol Displays whether to print a protocol monitor report after every fax transmission or
only when an error occurs.
Country Displays the country where the printer is used.
Power Saver Timer Sleep *1 Available Range:
5– 30 minutes
Specifies the time taken by the printer before it enters Sleep
mode after it finishes a job.
Deep Sleep Available Range:
1–6 minutes
Specifies the time taken by the printer before it enters Deep
Sleep mode after it goes into Sleep mode.
Auto Reset 45 seconds Specifies the time taken by the printer before it automatically resets the settings for
Copy, Scan, or Fax on the operator panel to the defaults when no additional
settings are made.
1 minute
2 minutes
3 minutes
4 minutes
Alert Tone Panel Select
Tone
Off Does not emit a tone when the operator panel input is correct.
Low Emits a tone at the specified volume when the operator panel
input is correct.
Medium
High
Panel Alert Tone Off Does not emit a tone when the operator panel input is
incorrect.
Low Emits a tone at the specified volume when the operator panel
input is incorrect.
Medium
High
Job Tone Off Does not emit a tone when a job is complete.
Low Emits a tone at the specified volume when a job is complete.
Medium
High