B&G H2000 Pilot *DISCONTINUED* - Manual (Page 19)

h2000 Autopilot User Manual
Part 2 - Operating Information
HB-0842-04
2-7
(3) Temporary Changes (Dodging) - At any Autopilot
display press the > Key next to the 10
o
legend to change
the Autopilot course to starboard by 10
o
. When the key is
pressed, the last course is stored in the Autopilot
Computer course memory. The Autopilot course digits
alternate between current and last course: Press the <
Key next to the 10
o
legend to change the Autopilot course
to port by 10
o
. The last course memory works as
described above.
At the Hand-held Controller press the Auto/Resume Key
to return to the original course.
USER TIP
The 10
o
and Last Keys can be used to "dodge" around
obstacles in the Autopilot’s course. Multiple key
operations are added together to give the required course
change, e.g. for a 20
o
course change press the 10
o
Key
twice.
Note
If the 1
o
Key is pressed immediately after pressing the
10
o
Key, the course memory is cleared and the last
course cannot be recalled. To return to the original
course use the Reciprocal Key.
2.3.6 Pre-Setting the Autopilot Course
(1) At any Autopilot Display, with the Autopilot System in
Standby, press the key next to the COURS legend to
display the Course Pre-setting Menu.
(2) Press the < Key (Decrease) and > Key (Increase)
next to the < < > > legend to alter the Autopilot course.
This is displayed on the LCD lower digits.
(3) Press the key next to the COMPS legend to engage
the Autopilot on the new pre-set course.
2.3.7 Pre-Setting the Next Leg
(1) At any Autopilot Display and with the Autopilot
engaged, press the key next to the N LEG legend to
display the Next Leg Pre-Setting Menu.