B&G H2000 Pilot *DISCONTINUED* User Manual
Page 137
h2000 Autopilot User Manual
Part 6 - Diagnostic Data
HB-0842-04
6-13
6.2.13
Fault 113 – Memory Card Changed
Fault Description
The memory card fitted is from another pilot and the
rudder end-stops are no longer valid. All other information
will remain intact.
Remedy
(1) A pilot reset is required to reset the characteristics.
Please consult your local authorised B&G Dealer for
assistance.
6.2.14
Fault 114 – Autopilot Memory
Fault Description
(1) The memory card fitted is not for a pilot or the pilot
software is not compatible with the contents of the card.
To use the card a system reset will need to be done.
(2) No memory card or faulty memory card present.
Please consult your nearest authorised B&G Dealer for
assistance.
Note
Fault 100 will indicate the presence of a valid pilot
memory card but contains no commissioning information.
Remedy
(1) Replace pilot memory card.
6.2.15
Fault 115 – Drive Communications Failure
Fault Description
The pilot microprocessor is unable to communicate with
the drive PCB.
Remedy
Check to ensure the high current supply is present or is
not too low.