Great Plains 1625AHL Operator Manual - Manual (Page 21)

Great Plains Manufacturing, Inc. Table of Contents Index Introduction 17
2014-04-21 Table of Contents Index 411-020M
Using This Manual
This manual familiarizes you with safety, assembly,
operation, adjustments, troubleshooting and
maintenance. Read it and follow the recommendations to
help ensure safe and efficient operation.
The information in this manual is current at printing.
Some parts may change to assure top performance.
Definitions
The following terms are used throughout this manual.
Right-hand and left-hand as used in
this manual are determined by facing
the direction the machine will travel
while in use unless otherwise stated.
An orientation rose in some line art
illustrations shows the directions of:
Up, Back, Left, Down, Front, Right.
Note: This set-off format indicates a useful point of
information related to the current topic.
Economic and/or Liability Risks:
This alert format contains a crucial point of information
related to the current topic. Read and follow the directions
provided before continuing, to ensure safety, avoidance of
machine damage, and to achieve desired field results.
Document Family
Owner Assistance
If you need customer service or repair parts, contact a
Great Plains dealer. They have trained personnel, repair
parts, and equipment specially designed for Great Plains
products.
Refer to Figure 2
Your planter’s parts were specially designed and should
only be replaced with Great Plains parts. Always use the
serial and model number when ordering parts from your
Great Plains dealer. The serial-number plate is located
near the right main transport tire, on the rear face of the
right riser of the front frame weldment.
Record your Planter model and serial number here for
quick reference:
Model Number:__________________________
Serial Number: __________________________
Your Great Plains dealer wants you to be satisfied with
your new machine. If you do not understand any part of
this manual or are not satisfied with the service received,
please take the following actions.
1. Discuss the matter with your dealership service
manager. Make sure they are aware of any problems
so they can assist you.
2. If you are still unsatisfied, seek out the owner or
general manager of the dealership.
U
D
F
B
L
R
411-020M Operator Manual (this manual)
411-020B Seed Rate Manual
411-020P Parts Manual
11001-1643
a
a. These are supplier part numbers.
DICKEY-john
®
IntelliAg
®
MVT Manual
11001-16
a
MVT Quick Start Guide
11001-1372
a
DICKEY-john
®
PM400 Console Manual
Bulletin A-27
a
Dwyer Magnehelic
®
instructions
12-M-43
a
CDS-John Blue
®
NGP-6050 Pump
For further assistance write to:
Product Support
Great Plains Mfg. Inc., Service Department
PO Box 5060
Salina, KS 67402-5060
Figure 2
Serial Number Plate
34535