Great Plains 1625AHL Operator Manual - Manual (Page 156)

152 1625AH Table of Contents Index Great Plains Manufacturing, Inc.
411-020M Table of Contents Index 2014-04-21
Marker Assembly
Install Marker Transport Rests
Refer to Figure 125 (C: to Center; W: to Wing)
For each wing:
15. Select one:
411-129H MARKER TRANSPORT REST WELDMENT
select two sets:
802-311C HHCS 1/2-13X4 1/4 GR5
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
16. Locate the marker support mount tube .
17. Orient the marker rest with the roller end up, and
the gusset to planter rear. Secure to mount tube
with bolts , lock washers and nuts .
Note: The remaining steps describe marker installation
with the planter in the as-shipped configuration,
which requires some high work. It is also possible
to unfold the planter, nearly fully unfold the
incomplete arms, and install the final sections at a
more convenient height. However, this requires
fully functioning monitor (including switch box) and
hydraulic connections, which may not be practical
unless the customer’s tractor is available.
Install Second Marker Sections
Refer to Figure 126 (C: to Center; W: to Wing)
For each wing:
18. Select one of:
113-010H PLANTER MARKER 2ND SECTION LH
113-481H YP1625 36TR MARKER 2ND SEC LH
or (not shown):
113-013H PLANTER MARKER 2ND SECTION RH
113-480H YP1625 36TR MARKER 2ND SEC RH
Identify the whether the arm is LH or RH, depending
on the wing involved.
Install Marker Hinge Pins
19. Select one each:
113-798D MARKER SHEAR PIVOT PIN
and two sets:
804-029C WASHER FLAT 1 SAE
805-058C PIN COTTER 3/16 X 2
Drive one cotter pin through an end hole (the top
hole) of the shear pivot pin . Add a washer
under the cotter.
Figure 125
LH Marker Transport Rest
36262
34
23
30
40
2
3
U
D
C
W
F
B
23
30
40
34
3
23
2
30 40 34
Figure 126
LH Marker Arm 2nd Section
34385
43
11
42
14
4
U
D
C
W
F
B
42
43
11
11
12
12
14
42
43
43
14 42