Great Plains V-300F Predelivery Manual - Manual (Page 34)

V300, V300F
148-057Q 1/2/2006
32
Refer to Figure 54
4. Place cotter pin in one of the holes in the pipe
handle. Slide washer over pipe and insert
pipe through spring coil.
Refer to Figure 55
5. Slide the second washer over pipe and insert
second cotter pin.
NOTE: It is not necessary to bend the cotter pins,
just use caution so they don’t fall out while stretch-
ing the spring.
Refer to Figure 56
6. Hold pipe and begin pulling spring towards
you.
21901
Figure 54
Inserting Handle
21902
Figure 55
Installing Washers and Cotter Pins
21903
Figure 56
Pulling Spring