Great Plains V-300F Predelivery Manual - Manual (Page 27)

1/2/2006 148-057Q
25 Assembly
Figure 41
Rear Walkboard with Small Seeds
Extension
23366
Rear Walkboard
Refer to Figure 41
NOTE: If equipped with small seeds, at-
tach small seeds extension before install-
ing rear walkboard.
1. Attach box to frame and rear walk-
board using 1/2-13 x 1 1/4 bolt (3), 1/2
lock washer, and 1/2-13 hex nut.
2. Using 1/2-13 x 1 1/2 bolt (1), two 1/2
flat washers (2), 1/2 lock washer (4),
and 1/2-13 hex nut (5), secure rear
walkboard (7) to frame.
3. Secure step (6) to rear walkboard (7)
using 1/2-13 x 1 1/2 bolt (1), 1/2 lock
washer (4), and 1/2-13 hex nut (5).
Rear Walkboard Handrail and Ladder
Refer to Figure 42
1. Attach ends of rear handrail crossbar (23) to walk-
board (6). Use 1/2-13 x 1 1/2 bolts (13), 1/2 flat
washers (10), 1/2 lock washers (9), and 1/2-13 hex
nuts (8).
2. Secure middle section of rear handrail crossbar (1) to walkboard (6) using 3/8-16 x 2
bolts (12), 3/8 flat washers (14), and 3/8-16 lock nuts (4).
3. Bolt folding ladder base mount (21) on walkboard (6) us-
ing 7/16-14 x 1 3/4 bolts (19), 7/16 lock washers (17), and
7/16-14 hex nuts (18).
4. Using 3/8-16 x 1 1/4 bolts (3), install 3-point
ladder weldment (20) on end support (21).
5. Attach rear handrail
crossbars (1) to middle
crossbar (22) with 3/8-16
x 3 bolts (5) and 3/8-16
lock nuts (4).
6. Bolt rear handrail cross bars (1) to rear
handrail (2) with 3/8-16 x 3 bolts (5) and
3/8-16 lock nuts (4).
7. Once rear handrail is assembled, se-
cure to walkboard with 3/8-16 x 2 bolts
and 3/8-16 lock nuts.
23357
Figure 42
Rear Walkboard Handrail