Great Plains V-300F Predelivery Manual - Manual (Page 29)

1/2/2006 148-057Q
27 Assembly
Rear Lights
Refer to Figure 44
1. Attach light bracket to right-hand side of V300
rear walkboard using 3/8-16 x 3/4 bolt, 3/8
lock washer, and 3/8-16 hex nut.
2. Remove hex nut from red triangle reflector.
Attach red triangle reflector to light bracket.
Secure with hex nut.
3. Remove hex nuts from red/amber round light.
Attach light to light bracket.
NOTE: The red/amber round lights come in a pair
of left and right. There is embossing on the left
light. The right light will have no embossing.
4. Secure light with hex nuts.
5. Attach light harness to light cord on back of
light.
6. Repeat steps 1 - 3 on left-hand side of drill.
Rear Safety Panels
Refer to Figure 45
1. Place red and white fluorescent panel on
back of rear walkboard.
2. Secure panel to rear walkboard hand rail us-
ing wiring and tube clip, 3/8-16 x 3/4 bolt, and
3/8-16 jam nut.
3. Attach slow moving triangle decal to the mid-
dle crossbar of rear walkboard handrail using
two 1/4-20 x 1 3/4 bolts and two 1/4-20 lock
nuts.
23364
Figure 44
Rear Lights
23365
Figure 45
Rear Safety Panels
23367