Metrohm 850 Professional IC MSM-HC MCS Prep 3 - Manual (Page 96)

5.5 High pressure pump
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
86 ￭￭￭￭￭￭￭￭
850 Professional IC Anion – MSM-HC – MCS – Prep 3
parts: a tip for removing the old piston seal and a sleeve for inserting the
new piston seal.
2
1
Figure 45 Tool for piston seal 6.2617.010
1 Pin
Pin for removing the old piston seal. 2 Sleeve
Sleeve for inserting the new piston seal.
Caution
Screwing the 6.2617.010 special tool for the piston seal into the piston
seal destroys this completely!
1 Removing the piston seal
Caution
Avoid touching the sealing surface in the pump head (18-4) with
the tool.
Screw the special tool for the piston seal (45-1) with the narrow side
just as far into the piston seal as the same can be removed.