Metrohm 850 Professional IC MSM-HC MCS Prep 3 - Manual (Page 25)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
850 Professional IC Anion – MSM-HC – MCS – Prep 3
￭￭￭￭￭￭￭￭ 15
6 Connecting the instrument
￭ Connect the instrument to the PC with a 6.2151.020 USB cable
(see Chapter 3.21.1, page 71).
￭ Connect instrument to mains supply (see Chapter 3.21.2, page
71).
7 Initial start-up
(see Chapter 4.1, page 76)
￭ Switch on the PC and start MagIC Net.
￭ Switch on the instrument.
￭ Deaerate the high pressure pump.
￭ Set contact pressure of the peristaltic pump.
￭ Rinse instrument without column.
8 Installing guard and separation column
￭ Remove the 6.2744.040 coupling between the column inlet capil-
lary and the eluent inlet capillary of the MSM-HC.
￭ Connect guard column (optional) (see Chapter 3.22, page 72)
– Fasten the guard column to the end of the column inlet
capillary according to the specifications contained in the
leaflet accompanying the guard column.
– Rinse guard column.
￭ Connecting the separation column (see Chapter 3.23, page 74)
– Fasten the inlet of the separation column either to the end
of the column inlet capillary or to the guard column (if
used) according to the specifications contained in the leaf-
let accompanying the column.
– Fasten the MSM-HC capillary labeled with Eluent with a
6.2744.070 PEEK pressure screw at the output of the sepa-
ration column.
￭ Hang separation column with chip in the column holder of the
instrument.
9 Conditioning the instrument
(see "Conditioning the system", page 77)
10 Installing the sample path
Connect the sample aspirating capillary and the sample outlet capil-
lary as well as the necessary capillaries for auxiliary solutions accord-
ing to the installation diagram.