Metrohm 915 KF Ti-Touch - Manual (Page 344)

28.9 Miscellaneous commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
330 ￭￭￭￭￭￭￭￭
915 KF Ti-Touch
Hold sequence
on | off (Default value: on)
If this parameter is activated, then the run will be paused during the
request. If this parameter is deactivated, then the method continues in the
background until the following measurement or titration has been com-
pleted.
28.9.4 Defining an acoustic signal (BEEP)
The BEEP command can be used to produce an acoustic signal.
Duration
Approximate playing time in seconds of the permanently stored melody.
Input range 1 - 9
Default value 1
28.9.5 Canceling the method run (END)
The method run will cancel as soon as the command END is reached. This
is a good idea if you wish to test only the first part of a method. No
parameters can be edited for this command.