CommScope Redwood version 3.1 - Manual (Page 27)

Commissioning and Administration User Guide 26
Activating and Deactivating a Scene
Activating a Scene immediately sets the Fixtures to their specified levels. When a Scene is
activated, you cannot perform task-tuning, but you can use Wall Switches and overrides.
Deactivating a Scene returns the lighting Policy to what is specified in the prioritized Event list.
To activate or deactivate a Scene:
Click the Location Settings tab or the Control tab. 1.
Select the Scene to activate or deactivate. 2.
Setting Scene Control Switches:
If a Location has a Scene Control Wall Switch, you can assign up to four Scenes to the Switch
buttons to allow users to select a particular Scene.
To assign a Scene to a Redwood Wall Switch
In the Maintenance tab, click the Location on the left and select the Wall Switch in the 1.
middle pane.
From the drop-down menu in the right pane, select Configuration. 2.
Under Scenes, map a Scene to a button from the options available in the drop-down menu. 3.
Click Apply. 4.