CommScope Redwood version 3.1 - Manual (Page 17)

Commissioning and Administration User Guide 16
Wall Switch
You can commission a Wall Switch using the same flashlight commissioning process as with a
fixture by shining a flashlight at the light sensor. You can also manually commission a Wall
Switch by connecting it to an Engine. When detected, the Wall Switch will automatically be
placed in the Unassigned group. You can then drag and drop the Wall Switch to the desired
location.
To add a Wall Switch manually:
In the Location Editor tab, select the Location. 1.
Drag the Wall Switch you want to add to the Location. 2.
To save this configuration change, click Apply, at the bottom left of the screen. 3.
Scene Control Wall Switch
When using the flashlight commissioning process to commission a Scene Control Wall Switch,
the four “scene” button LEDs will blink during commissioning, and you then press any Scene
Control Wall Switch button to assign the name and stop the blinking. You can also manually
commission a Scene Control Wall Switch by connecting it to an Engine. When detected, the
Scene Control Wall Switch will automatically be placed in the Unassigned group. You can then
drag and drop the Scene Control Wall Switch to the desired location.
To add a Scene Control Wall Switch manually:
In the Location Editor tab, select the Location. 1.
Drag the Scene Control Wall Switch you want to add to the Location. 2.
To save this configuration change, click Apply, at the bottom left of the screen. 3.