CommScope Redwood version 3.1 - Manual (Page 18)

Commissioning and Administration User Guide 17
Adding Additional Hardware After Commissioning
You can add Fixtures at any time after the initial configuration is complete. When detected, they
are automatically placed in the Unassigned group. You can add Fixtureless Gateways to the
same Locations as LEDs and fluorescents. They do not participate in light-control features nor
limit the functionality for a Location.
To add a Fixture or switch:
In the Location Editor tab, select the Location. 1.
Drag the Fixtures you want to add to the Location. 2.
To save this configuration change, click Apply at the bottom left of the screen. 3.
IMPORTANT NOTE
Fixtureless Gateways can be added to the same Locations as LEDs and Fluorescents. They
will not participate in any light control related features, nor limit the functionality listed under
lighting control for a Location.
Adjusting Motion Sensor Sensitivity
You can disable the motion sensor or set the sensitivity level. Disabling the sensor causes the
Fixture’s Location to ignore the Sensor’s motion data.
To set motion sensor sensitivity:
In the Maintenance tab, click the Location on the left and select the Fixture in the middle 1.
pane.
From the drop-down menu in the right pane, select Configuration. The Sensor model is 2.
listed under Sensor Type.
Under Sensitivity, select the sensitivity level from the drop-down menu. The Sensor type 3.
determines the sensitivity levels presented.
Click Apply. 4.