CommScope Redwood version 3.1 - Manual (Page 24)

Commissioning and Administration User Guide 23
Un-Sharing a Motion Signal
Select the Location (or Fixture) that has the Sensor you want to “share” motion from using 1.
the Maintenance tab.
Select Configuration on the pull-down directly below the Maintenance tab. You will see a 2.
listing of the current Locations that are Recipients of motion signals from this Donor Location.
Select the Recipient Location on the list that you wish to stop receiving motion signals and 3.
click on the icon.
You will be asked to confirm. 4.
Where did that Motion Signal come from?
Select the Location from the Location Settings tab. 1.
You will see for each Location a Shared Motion 2.
Events data item that is either set to Enabled or
Disabled.
If it is set to Disabled, then there are no motion signals being “shared” with this Location. If 3.
Enabled, then there are motion signals being “shared” with this Location.
If it is Enabled, then you can mouse over the “Share Motion Events: Enabled” text and a 4.
popup list of all Donor Locations (and/or Fixtures) will be displayed.
Copying Events
It is possible to copy the Events from one Location to another with the Copy Event feature.
To Copy one or more Events:
Select the source Location from the Location Settings tab. 1.
Click the Copy Events 2. button on the top of the dialog box.
Select the Event(s) that you wish to copy to another location and Click Next. 3.
Select the Location(s) that you wish to receive the Event(s) and Click Finish. 4.