Brandmotion FDMC-1210 - Manual

INSTALLATION
INSTRUCTIONS
1210 Instructions 6-27-14.docx Page 1 of 12
Qi Wireless Charging Installer Kit
(Kit # FDMC-1210)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit: Tools & Supplies Needed:
Qi Wireless Charging Module with
Full Size Trim to Fit Substrate
Power Harness with 3 amp Fuse
Full Size Trim to Fit Non Slip Mat
4 – Flat Head Torx 1/4" Screws
4 – Flat Head Torx 1/2" Screws
4 – Flat Head Torx 1” Screws
4 – Pan Head Torx 3/8” Screws
These Instructions with Trim Template
Removable Consumer Product Label
Plastic Trim Removal Tool
T-15 and T-10 Torx Driver
Phillips Screwdriver (if needed)
7mm, 10mm Socket Drive (if needed)
Center Punch/Scribe Tool
Power Drill
1/8’’, 3/8” and 1/2” Drill Bits
Scissors
X-Acto Knife
Wire Ties
Soldering Iron & Solder
(Recommended)
Tape or Heat Shrink Electrical Tubing
Multi Meter or 12V test light
*Note this product is designed to work with Qi compatible devices. Please confirm that
your device is Qi compatible before installation. Visit
www.brandmotion.com for phone
compatibility guide.
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
This kit is designed to be customized to fit your specific vehicle application. The following
instructions will be your guide to show you the basic steps of the installation. Your
vehicles installation may vary from these steps shown in these instructions.
IMPORTANT: Do not place smart keys
within 6 inches of charging mat.
Vehicle may not detect key to start
vehicle. Do not place metal objects in
tray while charging.