Rockwell Automation FactoryTalk AssetCentre Installation Guide 5.0 User Manual
Page 31
3
•
I
NSTALLING
THE
F
ACTORY
T
ALK
A
SSET
C
ENTRE
SERVER
25
•
•
•
• •
Microsoft Internet Explorer and any FactoryTalk AssetCentre installation windows
before restarting.
Microsoft .NET Framework 3.5 and 4.0. The FactoryTalk AssetCentre server
requires that Microsoft .NET Framework 3.5 and 4.0 be installed on your computer. If
this component is not already installed on your computer, the setup program will
install it.
FactoryTalk AssetCentre Upgrade Check. Checks for an existing CPR 7 version of
FactoryTalk AssetCentre. Version 5.00 works with all CPR 9 versions of FactoryTalk
Services Platform and cannot be installed with an existing CPR 7 version of
FactoryTalk AssetCentre. To upgrade, see Chapter 2 “Upgrading from version 2.00
(CPR 7) to 5.00 (CPR 9 SR 6)” beginning on page 12.
FactoryTalk Services Platform. See “Installing FactoryTalk Services Platform” on
page 26.
FactoryTalk Activation. See “Installing FactoryTalk Activation” on page 27.
RSLinx Enterprise. See “Installing RSLinx Enterprise” on page 29.
Patch FTSP. See “Patch FactoryTalk Services Platform” on page 29.
FactoryTalk Services Platform patches are installed depending on whether
FactoryTalk Services Platform version 2.10 is installed on the computer:
If the computer already has FactoryTalk Services Platform version. 2.10, patches
are installed during the FactoryTalk Services Platform installation (beginning on
page 26). This installs the most recent patches at the time the FactoryTalk
AssetCentre installation disc was created. More recent patches may be available.
If you have not already checked your FactoryTalk Services Platform patches, skip
the patch during the installation and see “Before you begin, check and install
FactoryTalk Services Platform and FactoryTalk View patches” on page 14 for
more information about validating and installing patches.
If the computer has an existing version of FactoryTalk Services Platform higher
than version 2.10 or does not have an existing version of FactoryTalk Services
Platform, no patches are necessary. FactoryTalk Services Platform version
CPR 9 SR 6 will be installed as part of the FactoryTalk AssetCentre installation.
Check and Configure FTSP. See “Check and configure FactoryTalk Services
Platform” on page 30.
Stop FactoryTalk AssetCentre Server. The FactoryTalk AssetCentre server service
must be stopped at this point in the installation. The installation program stops the
service.
FTAC-IN005A-EN-E.book Page 25 Monday, March 4, 2013 4:03 PM