Rockwell Automation FactoryTalk AssetCentre Installation Guide 5.0 - Manual (Page 20)

14
3
Installing the FactoryTalk AssetCentre
server
To upgrade an RSMACC system to FactoryTalk AssetCentre, follow the instructions in
Answer ID 454396 at http://rockwellautomation.custhelp.com/cgi-
bin/rockwellautomation.cfg/php/enduser/std_adp.php?p_faqid=454396
Before you begin, check and install FactoryTalk Services
Platform and FactoryTalk View patches
If you are installing on a computer that already has FactoryTalk Services Platform 2.10.00
or later, or FactoryTalk View 5.00 or later, you may need to manually install the patches.
You may have more recent patches than those included on the FactoryTalk AssetCentre
disc at the time of release. It is very important to check and install the patches before you
begin the FactoryTalk AssetCentre installation.
To install the patches:
IMPORTANT: If you are using a firewall (such as the Windows Firewall), you must manually
permit File and Printer Sharing through your firewall. Consult the documentation for your
firewall software for instructions. You must also open Port 80 (or whatever port is used for HTTP).
If the computer already has Then install patches by following instructions in
FactoryTalk Services Platform 2.10.00 or
later Answer ID 49190 at
http://rockwellautomation.custhelp.com/cgi-
bin/rockwellautomation.cfg/php/enduser/std_adp.php
?p_faqid=49190
FactoryTalk View 5.00 Answer ID 47015 at
http://rockwellautomation.custhelp.com/cgi-
bin/rockwellautomation.cfg/php/enduser/std_adp.php
?p_faqid=47015
FactoryTalk View 5.10 Answer ID 66056 at
http://rockwellautomation.custhelp.com/cgi-
bin/rockwellautomation.cfg/php/enduser/std_adp.php
?p_faqid=66056
FTAC-IN005A-EN-E.book Page 14 Monday, March 4, 2013 4:03 PM