Rockwell Automation DeviceNet Media Design Installation Guide - Manual (Page 76)

Publication DNET-UM072C-EN-P - July 2004
3-16 Make Cable Connections
Pinout diagrams for mini and micro connections to the power cable are shown
below.
Connect a Power Supply to
Round Media To supply power you will need to install and ground the power supplies as well
as connect all PowerTap taps. If you haven’t determined power supply
placement, see Chapter 4.
To install a power supply:
1. Mount the power supply securely allowing for proper ventilation,
connection to the ac power source, and protection from environmental
conditions according to the specifications for the supply.
2. Connect the power supply using:
• a cable that has one pair of 12 AWG (3.3mm
2
) conductors or the
equivalent or two pairs of 15 AWG (1.7mm
2
) conductors
• a maximum cable length of 3m (10 ft) to the PowerTap tap
• the manufacturer’s recommendations for connecting the cable to the
supply
V-
user defined
V+
not used
user defined mechanical key
5-pin Micro Female
2 3
4
5
1
V-
user defined V+
not used user defined
mechanical key
5-pin Mini Female
2
3
4
5 1
V+ user defined
V- user defined
mechanical key
4-pin Mini Female
2 3
4 1
30498-M
ATTENTION
Make sure the ac power source remains off during
installation.