Rockwell Automation DeviceNet Media Design Installation Guide - Manual (Page 51)

Publication DNET-UM072C-EN-P - July 2004
Identify Cable System Components 2-15
About KwikLink Insulation Displacement Connectors (IDCs)
KwikLink Insulation Displacement Connectors (IDCs) interface drop cables
and devices to the flat cable trunkline. The hinged, two-piece base snaps
around the flat cable at any point along the trunk. Contact is made with the
cable conductors by tightening two screws that drive the contacts through the
cable jacket and into the conductors. The snap-on interface provides the
connection to the drop cable and is available in micro-, open-, and
general-purpose style connectors.
Allen-Bradley KwikLink connectors are approved only with the following
DeviceNet flat cables:
Catalog Number Description
1485C-P1E CL1
1485C-P1L Aux. Power
1485C-P1G CL2
Description Catalog Number
NEMA 6P, 13; IP67
Micro module
w/base 1485P-P1E4-R5
NEMA 1; IP60
Micro module
w/base (no
gaskets) 1485P-P1H4-R5
Open-style module
w/base (no
gaskets) 1485P-P1H4-T4
KwikLink General
Purpose Connector,
Micro
1
1485P-K1E4-R5
1 Use this connector also with KwikLink General
Purpose Flat Cable (1485C-P1K).
41711 41717
49 mm
(1.93 in.) 40 mm
(1.58 in.)
36 mm
(1.40 in.)
45 mm
(1.75 in.)
49 mm
(1.93 in.)
40 mm
(1.58 in.)
36 mm
(1.40 in.)
45 mm
(1.75 in.)
V+
CAN_H
CAN_L
V-