Rockwell Automation DeviceNet Media Design Installation Guide - Manual (Page 64)

Publication DNET-UM072C-EN-P - July 2004
3-4 Make Cable Connections
7. Attach wires to the connector using screw terminals as seen in the
following diagram.
8. Screw the enclosure body to the connector.
9. Screw the rear nut into the connector enclosure.
Install DeviceBox and
PowerTap Taps Cable preparation and attachment is the same for PowerTap taps and
DeviceBox taps which use hard-wire connections of round media. To install
your taps, perform the following steps and then proceed to the appropriate
section for wiring the specific tap.
1. Remove the cover from the tap.
2. Prepare the ends of the cable sections.
a. Strip 65 mm (2.6 in.) to 76 mm (3 in.) of the outer jacket
and braided shield from the end of the cable.
b. Leave no more than 6.4 mm (0.25 in.) of the braided shield exposed.
TIP
The following illustration shows a mini male and female
connector. Connections are similar for micro connectors.
male connector female connector
power conductors
power conductors red
red
black
black
white
white
signal conductors
signal condctors
bare
bare bare
blue blue
Rear View Rear View 41848
bare
IMPORTANT
Do not twist or pull the cable while tightening the rear nut.
jacket
76 mm
(3 in.)
41843
6.4 mm
(0.25 in.)
braided shield
41844