Rockwell Automation DeviceNet Media Design Installation Guide - Manual (Page 73)

Publication DNET-UM072C-EN-P - July 2004
Make Cable Connections 3-13
8. Line up the keyed rectangular holes of the micro/open/terminator
connection interface with the matching posts on the base and snap the
micro module into place. Optional: Secure the micro/open/terminator
module by driving an 8-32 x 1-3/4 screw through each of the two
remaining mounting holes.
Install a KwikLink open-style connector to a drop cable
Install the KwikLink open-style connector to the flat media using the
directions starting on page 3-10. Prepare the drop cable following the
directions on page 3-2 numbers 1 through 5. For flat media connections you
can use:
• round 4-wire (KwikLink) drop cable (1485K series)
• round 5-wire (thin) drop cable (1485R series)
TIP
When using the cable in applications with a large amount
of flexing, secure the cable to a fixed reference point, using
an 8-32 x 1-3/4 screw through each of the two remaining
mounting holes. Attach the cable 10-15 cm (4-6 in.) from
the connector.
30478-M
two remaining
mounting holes