Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 54)

3–8 Installing PanelView 1200e Terminals
Publication 2711E-821 – January 1998
Mounting a Clip-Mount Touch Terminal in a Panel or Wall Cutout
Note: Clip-mount touch screen terminals have NEMA 12 and 13
ratings.
1. Make the appropriate cutout in the wall or panel location. Figure
3.7 shows the cutout dimensons for the clip-mount terminal.
2. Insert the terminal into the panel or wall cutout.
Figure 3.7 Clip-Mount Touch Screen Terminal Panel
Cutout
C
C
L
L
23651
CUTOUT
12.50 ”
(318 mm)
12.50 ”
(318 mm)
CL
CL
6.25 ”
(159 mm)
Four mounting clips are provided with the clip-mount touch
screen terminals. See Figures 3.8 and 3.9 for details of the
following procedures.
To assemble the clips:
1. Snap the foot pad onto the end of the panel mount screw.
2. Insert the screw into the mounting clip from the front until less
than one inch of the screw protrudes from the front of the
mounting clip.
To install the clips:
1. Hook each clip into its mounting slot on the side of the terminal.
2. Tighten the screws until the chassis is held snugly in place against
the panel. A torque of 10 inch-pounds provides a good seal. Do
not over-tighten the screws.
"