Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 35)

2–4 Installing PanelView 1000e Terminals
Publication 2711E-821 – January 1998
You need the following tools to make a wall or panel cutout and
install a PanelView 1000e terminal in it. The terminal shipment
includes a terminal cutout template for your use.
Note: Converted metric values have been rounded off. This applies
to the dimensions specified in the drawings in this chapter.
To make a rectangular wall or panel cutout, you need these tools:
•
center punch
•
scriber
•
hammer
•
power jig saw
•
set of drill bits (1/8 to 3/8 inch)
•
metal ruler for drawing lines on the panel
•
power drill
•
torque wrench
•
metal file
To install the terminal, you need this tool:
•
slot screwdriver or Phillips screwdriver
You can install your PanelView 1000e terminal in a rectangular
cutout in a panel or wall or in a 19-inch rack with the adapter kit.
The terminals are mounted with mounting clips.
Note: When choosing a location in which to install the PanelView
terminal, we recommend you provide at least 3.75 inches (9.5 cm)
clearance around the terminal from the panel or rack in which it is
installed, for proper ventilation.
Mounting a Clip-Mount Touch Screen Terminal in a Panel or Wall
Cutout
To prepare the location:
1. Make the appropriate cutout in the wall or panel location. Figure 2.4
shows the cutout dimensions for the clip-mount terminal.
2. Insert the terminal into the panel or wall cutout.
Tools for Installing Your
PanelView 1000e Terminal
"
Mounting Options for
PanelView 1000e
Terminals
"