Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual User Manual
Page 174

Installing the PanelView Serial Firmware Upgrade Utility
D–3
Publication 2711E-821 – January 1998
5. If you are installing on Windows 95, the Select Components
dialog box appears. Choose Version 3, and then choose Next.
If you are installing on Windows 3.x, the Select Components
dialog box does not appear. Version 3 is automatically selected.
6. In the Choose Applications dialog box, choose Serial Firmware
Upgrade as the application you want to install. You can choose
more than one application to install. Then choose Next.
7. In the Welcome dialog box for the Serial Firmware Upgrade
Utility, it recommends that you close all open Windows
applications. If you have done that, choose Next.
8. Choose the drive and directory in which the PanelView Serial
Firmware Upgrade Utility will be installed. By default, this is
C:\AB\PB1400e\SFU. To change the destination drive or
directory, type the new drive and/or directory in the Directory
field. Then choose Next.
9. Choose the program folder (program group) in which you want to
install the PanelView Serial Firmware Upgrade Utility’s icons,
which includes a Readme file icon, the Utility file icon, and an
Uninstall icon. By default, the icons are installed in the
PanelBuilder 1400e program folder. Then choose Next.
10. Follow the setup instructions as they appear on your screen.
To complete the setup, enter any required information when
prompted.
Do not cancel the installation while it is in progress. If you want
to cancel the installation, let the installation finish, then use the
Uninstall Serial Firmware Upgrade Utility to remove all the
installed files.
11. When the installation is complete, remove the CD-ROM from the
drive.