Rockwell Automation 6188 Workstation User manual - Manual (Page 5)

Operator Display Station Feature Overview 5
Publication 6188-UM001A-EN-P
or floor pedestal mounting option. Both of these mounting options
provide side-to-side swivel (180
°
) and tilt (30
°
) for optimum viewing.
•
Wall Mount Arm and Overhead
For applications where floor or tabletop space is limited, consider the
overhead or wall mount arm options.
The overhead mount option allows you to mount the Operator
Display Station above the operator in a fixed position. This option
gives you 30
°
tilt adjustment.
Each wall mount arm provides 360
°
swivel, 30
°
tilt, and full side-to-
side positioning. Vertical positioning options depend on the
enclosure material.
Enclosure Options
The RAC6188 can withstand the rigors of your harsh environment. In
addition to its ergonomic design, the RAC6188 is rugged. You can chose
from:
Environmental Rating NEMA 4/12 NEMA 4X
Construction Material Painted aluminum,
powder coat finish Type 316L
Stainless Steel
Remote Operation with Signal Extender
You can install the Operator Display Station up to 400 ft (122 m) away
from any standard PC computer.
You can install the 6188 on the factory floor where the environment is
harsh and space is at a premium, and then connect the Operator Display
Station to the signal transmitter located on the other side of the plant.
Simply connect the signal transmitter to the host PC.
You can connect to the host computer using your own low-cost, twisted-
pair Cat-5 cable. The video, keyboard, mouse, and touchscreen host
signals are multiplexed across the Cat-5 cable by the transmitter, located
at the computer and the transmitter in the Operator Display Station.
You can even connect an additional monitor, keyboard, and mouse to the
transmitter for backup, troubleshooting, setup and local control. All
power for the signal extender transmitter is supplied by the Operator
Display Station.