Rockwell Automation 6188 Workstation User manual - Manual (Page 10)

10 6188 Operator Display Station
Publication 6188-UM001A-EN-P
1. Open the top cap from the
shipping box.
2. Make sure the unit is free from defects, scratches, or other blemishes
in appearance. All Allen-Bradley products are shipped in specially
designed boxes with foam inserts, to minimize the possibility of
damage. However, if a problem has occurred in shipping, please
make note on the bill of lading, contact the shipping carrier
immediately and notify Allen-Bradley of the circumstances. In
addition, save all packing materials and take pictures of the damage
noted.
3. Make sure that the unit(s) and all accessories listed on the packing
slip are included.
4. With the assistance of 2-3 people, carefully lift unit out of the box by
reaching under the unit, on the sides.
5. Place the unit on a flat, level surface for further inspection.
6. Select on of the basic mounting configurations.
Mounting on a Table-Top
1. No assembly is required. Simply place the unit onto the table or
bench top.
2. You may want to adjust (tilt) the workstation forward or backward to
the best ergonomic position.
3. Tighten down the palm grip handles to lock it in place.
Mounting on a Pedestal
1. Bolt the mounting pedestal to the floor.
2. Then bolt the workstation to the mounting pedestal using hardware
supplied.
The (4) hole pattern in the 9”x9” top mounting plate matches the
hole pattern in the bottom of the yoke assembly.
3. Tilt the workstation forward or backward to the best ergonomic
position and tighten down the palm grip handles to lock it in place.
Unpacking the Operator
Display Station
Mounting the Operator
Display Station