Rockwell Automation 6188 Workstation User manual - Manual (Page 21)

Performing Routine Maintenance 21
Publication 6188-UM001A-EN-P
Performing Routine Maintenance Performing Routine Maintenance Performing Routine Maintenance Performing Routine Maintenance
Occasionally clean the Operator Display Station with a soft cloth
dampened (not soaked) with a mild (non-abrasive) glass cleaner. Keep
turning a fresh side of the cloth toward the screen surface to avoid
scratching it with accumulated grit.
Note:
The solvent should be applied only to the cloth, and not
directly on the monitor screen.
Do not use paper products as they may scratch the surface.
To minimize the risk of abrasion, allow the screen to
stand dry.
ATTENTION: You can use alcoholic or ammoniacal
cleaners to clean the polycarbonate shield or a
touchscreen. However, use only one or the other at all
times. A residue mixture can cause a chemical reaction.
Special care should be taken when cleaning a touchscreen or
polycarbonate shield that is installed over the screen. Abrasive and
certain chemical cleaners can easily damage the surface.
To avoid shock and fire hazards, the Operator Display Station’s power
cord should be replaced if the insulation becomes broken or if it develops
a loose internal connection.
Qualified service personnel should perform all maintenance, except for
the power cord replacement described above.
Cleaning
Replacing a Line Cord
Other Maintenance