Rockwell Automation 6188 Workstation User manual - Manual (Page 11)

Setting up Your Operator Display Station 11
Publication 6188-UM001A-EN-P
Mounting Using a Flex Arm
1. Bolt the flex arm mounting plate to the mounting surface (wall or tall
pedestal) using the hardware supplied.
2. Then remove the yoke from the Operator Display Station enclosure
and mount it to the swivel part of the flex arm using the hardware
provided.
3. Re-assemble the yoke to the Operator Display Station enclosure
using the two side-mount palm grip handles. This may require 1 or 2
people to hold the enclosure while installing the palm grip handle
studs through the yoke index plates and into the workstation yoke
mounts.
4. Tilt the workstation forward or backward to the best ergonomic
position and tighten down the palm grip handles to lock it in place.
WARNING: Once installed into the yoke, do not loosen
the palm grip handles more that 1 or 2 turns while
adjusting the workstation’s tilt position. Unscrewing the
palm grip handles to far can cause the workstation to
detach from the yoke and drop.
Mounting Overhead
1. Remove the yoke from the Operator Display Station.
2. Bolt the yoke to an overhead surface.
3. Re-assemble the yoke to the Operator Display Station enclosure
using the two side-mount palm grip handles. This may require 1 or 2
people to hold the enclosure while installing the palm grip handle
studs through the yoke index plates and into the workstation yoke
mounts.
4. Tilt the workstation forward or backward to the best ergonomic
position and tighten down the palm grip handles to lock it in place.