Rockwell Automation 6176M-xxxx Standard Industrial Monitors User Manual - Manual (Page 35)

Rockwell Automation Publication 6176M-UM001D-EN-P - December 2012 35
Chapter
4
Perform Routine Maintenance
Chapter Objective This chapter describes how to clean the monitors, replace a line cord, and
perform other routine maintenance.
Clean the Monitor Occasionally clean the display panel and cabinet with a soft cloth dampened (not
soaked) with a mild (non-abrasive) glass cleaner. Keep turning a fresh side of the
cloth towards the screen surface to avoid scratching it with accumulated grit.
Displays and touch screens are resistant to the following chemicals:
• Ethyl alcohol
• Methyl alcohol
• Cleaning naphtha
• Commercial glass cleaners
• Ammonia in 10% diluted solution
Be careful when cleaning a touch screen shield that is installed over the screen.
Abrasive and certain chemical cleaners can easily damage the surface.
Replace a Line Cord To avoid shock and fire hazards, replace the monitor’s power cord if the
insulation breaks or if the cord develops a loose internal connection. Contact
your authorized Allen-Bradley distributor for ordering information.
IMPORTANT Apply the solvent only to the cloth, and not directly on the monitor screen. Do
not use paper products as they may scratch the surface. To minimize the risk of
abrasion, allow the screen to air dry.
ATTENTION: You can use alcoholic or ammonia cleaners to clean the
polycarbonate shield or a touchscreen. However, use only one or the other at all
times. A residue mixture can cause a chemical reaction.
Cat. No. Description
6189V-SCRNCOVER15 15" Screen Cover for flat front bezels
6189V-SCRNCOVER17 17" Screen Cover for flat front bezels